Batteries for Golf Carts
Before driving a long distance to purchase batteries, please give
us a call to confirm the price and availability.
Price is subject to change, before our Webmaster* has the new info entered on this page.
*Note the webmaster is my father, and he is old & slow. He's doing the best that he can.
us a call to confirm the price and availability.
Price is subject to change, before our Webmaster* has the new info entered on this page.
*Note the webmaster is my father, and he is old & slow. He's doing the best that he can.
T605 Trojan battery
6 volt battery MSRP $145.92 Your price $89.97 each Set of 6 $539.82 |
T105 Trojan Battery
6 volt battery MSRP $169.62 Your Price $99.97 each Set or 6 $599.82 |
T1275 Trojan Battery
12 volt battery MSRP $257.47 each Your price $159.50 each Set of 4 $598.00 |
T875 Trojan Battery
8 volt battery MSRP $178.55 Your price $109.50 Set of 6 $657.00 |
|
|
|
P2000 Powertron Battery
6 volt battery MSRP $ 128.06 each Your Price $69.75 each Set of 6 $418.50 |
P8000 Powertron Battery
8 volt battery MSRP $141.52 each Your Price $84.00 each Set of 6 $504.00 |
*************************************************************************
**********************************************************************************************************************************************************
Tech Tips & Batteries Maintenance
For optimum performance and battery life, the rule of thumb is to charge often. Today's electric golf cars have much better electronics and charging systems than years past. The two are designed to work together (charger & car/batteries) You must have good batteries and charger, having a weak cell in a battery or a weak battery will effect the charging cycle. With good batteries and a charger that is working to specification, normal charge cycles can vary from 2 hours, to as much as 18 hours, depending on the state of charge in the batteries or the age of the batteries.
The batteries water level should be checked once a month. While you do the maintenance, you should always clean the batteries entirely as well as the cables and post. When adding water make sure the batteries are charged first, batteries that are low on charge will overflow during a normal charge if you where to fill the batteries to the recommended level before charging. Always used distilled water. The battery nuts should always be checked for tightening after cleaning and refilling.
The batteries water level should be checked once a month. While you do the maintenance, you should always clean the batteries entirely as well as the cables and post. When adding water make sure the batteries are charged first, batteries that are low on charge will overflow during a normal charge if you where to fill the batteries to the recommended level before charging. Always used distilled water. The battery nuts should always be checked for tightening after cleaning and refilling.
**********************************************************************************************************************************************************
Information & Tips From The Manufacturer Of Trojan Batteries
Watering (Flooded batteries only)
Flooded batteries need water. More importantly, watering must be done at the right time and in the right amount or else the battery's performance and longevity suffers.
Water should always be added after fully charging the battery. Prior to charging, there should be enough water to cover the plates. If the battery has been discharged (partially or fully), the water level should also be above the plates. Keeping the water at the correct level after a full charge will prevent having to worry about the water level at a different state of charge.
Depending on the local climate, charging methods, application, etc. Trojan recommends that batteries be checked once a month until you get a feel for how thirsty your batteries are.
Important things to remember:
1. Do not let the plates get exposed to air. This will damage (corrode) the plates.
2. Do not fill the water level in the filling well to the cap. This most likely will cause the battery to overflow acid, consequently losing capacity and causing a corrosive mess.
3. Do not use water with a high mineral content. Use distilled or deionized water only.
CAUTION: The electrolyte is a solution of acid and water so skin contact should be avoided.
Step by step watering procedure:
1. Open the vent caps and look inside the fill wells.
2. Check electrolyte level; the minimum level is at the top of the plates.
3. If necessary add just enough water to cover the plates at this time.
4. Put batteries on a complete charge before adding any additional water (refer to the Charging section).
5. Once charging is completed, open the vent caps and look inside the fill wells.
6. Add water until the electrolyte level is 1/8" below the bottom of the fill well.
7. A piece of rubber can be used safely as a dipstick to help determine this level.
8. Clean, replace, and tighten all vent caps.
WARNING: Never add acid to a battery.
Flooded batteries need water. More importantly, watering must be done at the right time and in the right amount or else the battery's performance and longevity suffers.
Water should always be added after fully charging the battery. Prior to charging, there should be enough water to cover the plates. If the battery has been discharged (partially or fully), the water level should also be above the plates. Keeping the water at the correct level after a full charge will prevent having to worry about the water level at a different state of charge.
Depending on the local climate, charging methods, application, etc. Trojan recommends that batteries be checked once a month until you get a feel for how thirsty your batteries are.
Important things to remember:
1. Do not let the plates get exposed to air. This will damage (corrode) the plates.
2. Do not fill the water level in the filling well to the cap. This most likely will cause the battery to overflow acid, consequently losing capacity and causing a corrosive mess.
3. Do not use water with a high mineral content. Use distilled or deionized water only.
CAUTION: The electrolyte is a solution of acid and water so skin contact should be avoided.
Step by step watering procedure:
1. Open the vent caps and look inside the fill wells.
2. Check electrolyte level; the minimum level is at the top of the plates.
3. If necessary add just enough water to cover the plates at this time.
4. Put batteries on a complete charge before adding any additional water (refer to the Charging section).
5. Once charging is completed, open the vent caps and look inside the fill wells.
6. Add water until the electrolyte level is 1/8" below the bottom of the fill well.
7. A piece of rubber can be used safely as a dipstick to help determine this level.
8. Clean, replace, and tighten all vent caps.
WARNING: Never add acid to a battery.
